HomeProductsAngled belt conveyorsAngled belt conveyor EM-K-W

Angled belt conveyor EM-K-W

The EM-K-W is a particularly robust flexible belt conveyor. Its stainless steel frame with a height of 95 mm is manufactured with a closed stainless steel profile.
As a standard, the belt conveyor EM-K-W is equipped with a chain with made of plastic modules with cross slats and corunning side plates. A hopper with a fall-back flap is mounted on the feed end.

The side plates can have a height of 1, 2 or 3 inches.

The length of the horizontal and inclined parts can be adjusted to the individual application. However, a total length of 4 meters should not be exceeded.

From the ground, the angle of inclination of the EM-K-W can be adjusted in steps of 5° between 20° and 70°.

The cross slats may be 1, 2 or 3 inches high and their distance on the conveyor between one another can be freely selected in 1-inch steps. The plastic modular chains of the EM-K-W have been approved by the FDA and are easy to clean. In addition, they are particularly hard-wearing and easy to service thanks to the possibility of replacing individual links.

As a standard, the horizontal part is provided with small rollers as support to enable an easy
movement of the belt conveyor. A double support can be inserted in the inclined part, as shown
in the figure above. A mobile H-shaped single column support can also be used.

Request quote!
Or call us directly under: +49 (0) 2461 / 93767-0

Technical Specifications and Accessories:

Useable belt widths (between the side plates) / Total belt widths:
136/228 mm, 212/304 mm, 288/380 mm, 364/456 mm, 440/532 mm, or 516/608 mm.

Distance between axes A1 horizontal: 500 to 3,500 mm. Any desired lengths are available.
Distance between axes A2 inclined: 500 to 3,500 mm. Any desired lengths are available.
Total length A1 + A2: at most 4,000 mm.

Drive unit with constant belt speed:
v = approx. 5.6 / 10.4 / 15.6 / 20.8 / 31.2 or 44.6 m/min. Further belt speeds are available upon
request. Supply for 220/240 - 380/415 V, 50 Hz. Protection type IP 54.
This drive unit can be delivered ready to be connected including a protective motor switch with
an emergency stop and a power line of 2 meters length with a CEE plug. Protection type IP 54.

Drive unit with infinitely adjustable belt speed:
v = approx. 2.2-7.8 / 4.2-14.6 / 6.2-21.8 / 8.3-29.1 / 12.5-43.7 or 17.8-62.4 m/min.
Other speeds are available upon request.
The belt is delivered with a connected digital frequency controller, ready to be plugged in for 230
V, 50 Hz. Protection type IP 65.

Geared motor position: The geared motor can be placed pulling on the left or right side. It can
be turned in single steps by 90°.

Total belt load: Standard load 30 kg. Higher loads are available upon request.