HomeProductsZ - shaped belt conveyorsZ-belt conveyor GAL-60-Z

Z-belt conveyor GAL-60-Z

The GAL-60-Z, unlike the GAL-60-K on page 43, has a third section at the upper end of the frame. The upper section allows horizontal delivery of goods even though they have previously been lifted.

Equipped with a slatted belt and fixed side rails, it is particularly well suited for bigger parts. For smaller and more delicate parts it is better to use a belt with corrugated edges, as shown on page 49.

The GAL-60-Z has a TorsioDur frame, that is very resistant to torsion. It is 60 mm high. Along its side it has grooves for sliding blocks with M-8 threads, in which additional accessories can easily be fitted.

The length of both horizontal and rising section can be made to fit the required application. In total however, a length of 4 metres should not be exceeded.

The angle of inclination for the rising part can be infinitely adjusted between 40 and 60° from the ground.

For easy feeding of the goods onto the conveyor, in standard configuration it is equipped with a small receiving hopper. The hopper has a fall back flap made from belt material, to ensure safe run of the slats through the hopper.

In the lower horizontal section, small casters are mounted to make it easy to move the conveyor around. In the rising section, as shown in this picture, a double support can be used. But it is also possible to use an H-shaped support on wheels with brakes.

Request quote!
Or call us directly under: +49 (0) 2461 / 93767-0

Technical Specifications and Accessories:

Belt widths:
100, 150, 200, 250, 300, 350, 400, 450 or 500 mm.

Rising distance between axes, A2: 500 to 3.000 mm. All intermediate lengths possible.
Horizontal distance at the top, A3: 500 to 3.000 mm. All intermediate lengths possible.
Total length A2 + A3:

Horizontal distance at the bottom, A1: 500 to 3.000 mm. All intermediate lengths possible.
Rising distance between axes, A2: 500 to 3.000 mm. All intermediate lengths possible.
Horizontal distance at the top, A3: 500 to 3.000 mm. All intermediate lengths possible.
Total length A1 + A2 + A3: no more than 4.000 mm.

Drive with constant belt speed:
v = approx. 4,6 / 8,5 / 12,8 / 17,1 / 25,6 or 36,6 m/min.
Other belt speeds are possible on request. Connection for 220/240 - 380/415 V, 50 Hz. Protection type IP 54. This drive can be supplied together with a motor protection switch incorporating an emergency off. It has a 2 metre supply cable and CEE plug and is of protection type IP 54.

Drive with infinitely adjustable belt speed:
v = approx. 1,8-6,4 / 3,4-12,0 / 5,1-17,9 / 6,8-23,9 / 10,3-35,9 or 14,6-51,3 m/min.
Other belt speeds are possible on request. The drive is supplied together with a frequency regulator that is ready to be plugged to 240V 50 Hz and has a protection type of IP 65. The frequency controller incorporates a digital motor protection switch.

Geared motor position:
Pulling the belt at its side, on the left or right.

Total belt load:
Standard is of 30 kg. Higher loads are possible on request.