HomeProductsZ - shaped belt conveyorsZ-belt conveyor GAL-60-ZW

Z-belt conveyor GAL-60-ZW

The GAL-Z-W, contrary to the GAL- 60-K-W has a third section at the upper end of the frame. The transported goods can be fed to a next machine, as though they came from a horizontal conveyor, although they have previously been lifted.

The corrugated edge belt can easily handle even the smallest and most delicate parts, without risking any damage.

The TorsioDur frame of the GAL-60-Z-W is very resistant to torsion and has a height of 60 mm. Along its side it has grooves for sliding blocks with M-8 threads. Additional accessories can easily be fixed here.

The length of both horizontal and rising sections can be custom made to fit the required application. In total however, a length of 4 metres should not be exceeded.

The angle of inclination of the rising part can be infinitely adjusted between 40 and 60° from the ground.

The height of the corrugated edge and the slats, as well as their spacing, can be made to measurement, in order to suit individual requirements.

In a standard configuration, small casters are mounted in the lower horizontal section, to make it easy to move the conveyor around. In the rising section, as shown in the picture on this page, a double support can be used. But an H-shaped support is also possible. All these support systems are infinitely adjustable in height and pivotable.

Request quote!
Or call us directly under: +49 (0) 2461 / 93767-0

Technical Specifications and Accessories:

Useable belt widths(between the corrugated edges) / Total belt width:
130/300 mm, 180/350 mm, 230/400 mm, 280/450 mm, 330/500 mm, 380/550 mm or 430/600 mm.

Rising distance between axes, A2: 500 to 3.000 mm. All intermediate lengths possible.
Horizontal distance at the top, A3: 500 to 3.000 mm. All intermediate lengths possible.
Total length A2 + A3:

Horizontal distance at the bottom, A1: 500 to 3.000 mm. All intermediate lengths possible.
Rising distance between axes, A2: 500 to 3.000 mm. All intermediate lengths possible.
Horizontal distance at the top, A3: 500 to 3.000 mm. All intermediate lengths possible.
Total length A1 + A2 + A3: no more than 4.000 mm.

Drive with constant belt speed:
v = approx. 4,6 / 8,5 / 12,8 / 17,1 / 25,6 or 36,6 m/min.
Other belt speeds are possible on request. Connection for 220/240 - 380/415 V, 50 Hz. Protection type IP 54. This drive can be supplied together with a motor protection switch incorporating an emergency off. It has a 2 metre supply cable and CEE plug and is of protection type IP 54.

Drive with infinitely adjustable belt speed:
v = approx. 1,8-6,4 / 3,4-12,0 / 5,1-17,9 / 6,8-23,9 / 10,3-35,9 or 14,6-51,3 m/min.
Other belt speeds are possible on request. The drive is supplied together with a frequency regulator that is ready to be plugged to 240V 50 Hz and has a protection type of IP 65. The frequency controller incorporates a digital motor protection switch.

Geared motor position:
Pulling the belt at its side, on the left or right.

Total belt load:
Standard is of 30 kg. Higher loads are possible on request.